Teflon sintered filter element

The polytetrafluoroethylene sintered filter element is made of pure polytetrafluoroethylene raw material, through high temperature and high pressure sintering, so the filter element has strong acid and alkali resistance, strong alkali ability, the strength and toughness of the filter element are ver

PE sintered filter element by scientific formula of high temperature sintering, has good mechanical properties, and the filter element aperture inside and outside the same, easy to backwash slag.The filter layer is thick and the working pressure is high to ensure the filtering effect.Production of large water treatment equipment, can use automatic or manual recoiling slag method, solid particle recovery can be used dry slag, do not need to often replace the filter element, can be automated operation, low filtration cost advantages, well received by users.

Advantage

1, PTFE filter pore size distribution uniform, strong acid, strong alkali, high temperature resistance.

2, good mechanical properties, corrosion resistance of more organic solvents.

3. Before leaving the factory, each filter element shall be tested for bubble uniformity to ensure uniform distribution of micropores.

4, scientific formula firing, particles bond firmly, not easy to fall off.

Working condition
Design pressure	0.7Mpa（5.0MPa With stent）
Maximum temperature resistance:	160°C
Filter Precision	0.1um~30um
Adapter interface:	Thread type, flat mouth type, insert type, with end cover type, flange type
Material
Filter material	PTFE
Interface material	PFA/PTFE/SS304/SS316/C22
Tube material	316L/304/PTFE/C22
Seal ring	SILICOME /PTFE/ PFA/EPDM/NBR/Fluororubber

Dimensions

	OD( mm )	Inner diameter( mm )	Filter length(mm)	Adapter interface	Interface material	Annular tubes	gasket
MRPTFE	31	20	200	M22*50	PP	Empty	( Empty )
	31: 31mm	16: 16mm	100mm-2000mm	M202.535	PP: JPP	No casing (Empty)	( Empty ): silicone rubber
	38: 38mm	18: 18mm	( The length is matched according to the actual mold size )	M22350	304: J304	PP: TPP	silica gel:( S)
	40: 40mm	20: 20mm		M22*60	316L: J316L	304: T304	PTFE: ( PTFE )
	45: 45mm	30: 30mm		M24	Fe: J20#	316L: T316L	EPDM: ( E )
	50: 50mm	38: 38mm		M25	Macromolecule: JG	PTFE: TPTFE	Nitrile butadiene:( N )
	63: 63mm	40: 40mm		M3/4	PTFE: JPTFE		Fluorelastomer :( F)
	78: 78mm	44: 44mm		DO: The two connected	(J): Other		Four fluorine coating: (PFA)
	100: 100mm	63: 63mm		D: custom
	130: 130mm	80: 0mm
	( Match with inner diameter according to actual mold size )	100: 100mm
		( Match with the outside diameter according to the actual mold size )